Accessories EE stopped responding to stylus on Eink side

Gerrye · 09-19-2013, 03:28 PM

My wacom stylus stopped working on the Eink side of my Edge (full size). I thought that the stylus might have gone bad, but I tested it on one of my PEs and the Eink screen responded.

I took a stylus from the PE and tried that on the EE and still no response.

Any thoughts out there before I do a system reset?

Thanks,

P.S. There was a discussion about this subject in September, 2011 for a PE stylus, but there were never any answers....

Gunnerp245 · 09-20-2013, 11:58 AM

Shut it off; do a complete charge; try again. If nothing changes try the reader calibration.

Gerrye · 09-21-2013, 07:49 AM

Gunner,

I tried a discharge/recharge twice, but there was no change. I cannot do a recalibration to the E-Ink side, as it still doesn't respond to the stylus.

Thanks for the suggestion...

ivanjt · 09-21-2013, 01:22 PM

It looks as if you will need to get out the tools and 'pop' the covers - check for screws under the rubber pads - because it sounds as if a cable has broken or worked loose.

Note, flat flexible plastic cables fit into sockets that have lift up locks at the top that will break if you are not careful. Other than that you are on your own because no one that has taken their EE apart supplied any pictures of the insides - think of an iFixit teardown.

Gerrye · 09-23-2013, 03:12 PM

Ivan, I think I'll go for the system reset first before I open the EE.

Thanks for the warnings though...

09-19-2013, 03:28 PM	#1
Gerrye Zealot Posts: 146 Karma: 10 Join Date: Mar 2011 Location: Leblon, Rio de Janeiro, Brazil Device: 1 EE,3 PEs,HP Pro Slate12.2,&Kindle Paperwhite,GalaxyTabPro12.2,Note 4	EE stopped responding to stylus on Eink side My wacom stylus stopped working on the Eink side of my Edge (full size). I thought that the stylus might have gone bad, but I tested it on one of my PEs and the Eink screen responded. I took a stylus from the PE and tried that on the EE and still no response. Any thoughts out there before I do a system reset? Thanks, P.S. There was a discussion about this subject in September, 2011 for a PE stylus, but there were never any answers....

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
E-ink side stopped working - suggestions?	Dingo	enTourage eDGe	6	08-23-2012 09:43 AM
Help, the eink side is no longer responding	Grizzylemon	enTourage eDGe	6	08-11-2011 07:24 PM
903 Stylus stopped reacting	avg_user	PocketBook	3	01-23-2011 10:16 AM
Android Is there a way to type in the eink side?	canezila	enTourage Archive	3	11-15-2010 02:37 PM
DR1000 HELP!! my stylus stopped working	splendor	iRex	7	06-16-2010 11:35 AM

09-20-2013, 11:58 AM	#2
Gunnerp245 Gadget Freak Posts: 1,169 Karma: 1043832 Join Date: Nov 2007 Location: US Device: EE, Note 8	Shut it off; do a complete charge; try again. If nothing changes try the reader calibration.

09-21-2013, 07:49 AM	#3
Gerrye Zealot Posts: 146 Karma: 10 Join Date: Mar 2011 Location: Leblon, Rio de Janeiro, Brazil Device: 1 EE,3 PEs,HP Pro Slate12.2,&Kindle Paperwhite,GalaxyTabPro12.2,Note 4	Gunner, I tried a discharge/recharge twice, but there was no change. I cannot do a recalibration to the E-Ink side, as it still doesn't respond to the stylus. Thanks for the suggestion...

09-21-2013, 01:22 PM	#4
ivanjt Guru Posts: 858 Karma: 1027478 Join Date: Aug 2010 Location: South of France Device: kindle dx; eDGe	It looks as if you will need to get out the tools and 'pop' the covers - check for screws under the rubber pads - because it sounds as if a cable has broken or worked loose. Note, flat flexible plastic cables fit into sockets that have lift up locks at the top that will break if you are not careful. Other than that you are on your own because no one that has taken their EE apart supplied any pictures of the insides - think of an iFixit teardown.

09-23-2013, 03:12 PM	#5
Gerrye Zealot Posts: 146 Karma: 10 Join Date: Mar 2011 Location: Leblon, Rio de Janeiro, Brazil Device: 1 EE,3 PEs,HP Pro Slate12.2,&Kindle Paperwhite,GalaxyTabPro12.2,Note 4	Ivan, I think I'll go for the system reset first before I open the EE. Thanks for the warnings though...

Advert

Advert