Onyx Boox M92 - Issues with Firmware v1.7 20111228

[Backi]

Issue 7: Exceeding vertical scribble boundaries (firmware 1.6?-1.7)

Draw something and then exceed the boundary on the left or right side. Then click somewhere on the screen again: Automatically a line is drawn between the point, where you exceeded the boundary and the point, where you clicked afterwards.

In this image I drew the (nearly) horizontal line and exceeded on the right side. Then I clicked down left, so that the diagonal line was automatically inserted.

I think, the scribble app misses to terminate the polyline, when the stylus exceeds the left or right boundary.

[kodomo]

page switch buttons are disabled in 2-point-zoom

[Booxtor]

Originally Posted by kodomo

page switch buttons are disabled in 2-point-zoom

We have already noticed the issue (it was also several times mentioned in other threads here). Give us a couple of days. Please also note, that 1.7 is not a final release yet - it is still betta and some issues are possible.

Please note that the thread here is about 20111228 and is out of date.

Next time please write your comments to the 1.7 here: https://www.mobileread.com/forums/sho...d.php?t=164162

[Mono]

Originally Posted by Backi

Issue 7: Exceeding vertical scribble boundaries (firmware 1.6?-1.7)
Draw something and then exceed the boundary on the left or right side. Then click somewhere on the screen again: Automatically a line is drawn between the point, where you exceeded the boundary and the point, where you clicked afterwards.

.....

I think, the scribble app misses to terminate the polyline, when the stylus exceeds the left or right boundary.

It happens also in 1.7b firmware. It always joins two separate polyline, if you leave left margin. I couldn't make M92 do it while leaving right, uppper, bottom margin.

That is something similar to bug that I 'hit' in pdf scribling. Only it seems to me the reason for loosing terminating signal for polyline is different than leaving screen by exeeding left margin.

This bug should be quite easily fixed. If I start getting position, I terminate previous first. Or just check if two adjacement polyline dots are not too distant (more than say 2 mm).

[Mono]

Originally Posted by Booxtor

Please also note, that 1.7 is not a final release yet - it is still betta and some issues are possible.

OK, it changes a situation a bit. ;-) I thought it is a final release.