MobileRead Forums - View Single Post - Tools Software Jailbreak for PW2, PW3, PW3W, KT2, KV, KOA and KT3

geekmaster · 07-13-2016, 02:55 PM

Code:

0003:1949:DEAD.0006: input,hidraw0: USB HID v1.11 Device [USB Charger ] on usb-0000:00:1d.0-2/input0

That is the "dead battery" fake 0MB usb device, used to keep the host from powering down USB while charging the kindle identification for a totally dead battery than cannot be charged. It indicates that your kindle battery is very discharged, but may also indicate ERASED firmware. Charge it for a couple of days on a wall charger (very slow trickle charge in that mode), then try slipping that file onto it. Be sure that your kindle has a full battery charge before attempting repair. See this update below:
https://www.mobileread.com/forums/sho...26#post3352626

Is it possible your kindle battery was discharged before firmware updates compelted? Not good if so, you MIGHT need to go the serial port route in that case. But charge it first and try again.

There is a GOOD REASON why charging the battery is listed as the third step in the "step by step" in the first post in this thread.

07-13-2016, 02:55 PM	#455
geekmaster Carpe diem, c'est la vie. Posts: 6,433 Karma: 10773670 Join Date: Nov 2011 Location: Multiverse 6627A Device: K1 to PW3	Code: 0003:1949:DEAD.0006: input,hidraw0: USB HID v1.11 Device [USB Charger ] on usb-0000:00:1d.0-2/input0 That is the "dead battery" fake 0MB usb device, used to keep the host from powering down USB while charging the kindle identification for a totally dead battery than cannot be charged. It indicates that your kindle battery is very discharged, but may also indicate ERASED firmware. Charge it for a couple of days on a wall charger (very slow trickle charge in that mode), then try slipping that file onto it. Be sure that your kindle has a full battery charge before attempting repair. See this update below: https://www.mobileread.com/forums/sho...26#post3352626 Is it possible your kindle battery was discharged before firmware updates compelted? Not good if so, you MIGHT need to go the serial port route in that case. But charge it first and try again. There is a GOOD REASON why charging the battery is listed as the third step in the "step by step" in the first post in this thread. Last edited by geekmaster; 07-13-2016 at 07:20 PM.