Quote:
Originally Posted by GeoffR
There is a 10MB area at the beginning of the card that appears unallocated, but the device actually uses this area directly, so don't overwrite it. The only reason to extend the user data partition is if you have written the image to a larger card and there is unused space at the end of the card.
|
In the guide it says to extend it, but if no necessary it's not a problem. Thank you.
Quote:
Originally Posted by oren64
You can solder USB cable, cut the cable in half and solder the wires
Or use micro-USB port.
V-Red(+)
Grounding-Black(-)
RX TX are the data, i almost certain that TX is green (d+), RX is white(d-).
Make sure that the wires don't touch each other or the board. |
Quote:
Originally Posted by Ken Maltby
Are you sure that is a USB port? most of those on my Aura HD are TTL Serial ports.
Luck;
Ken
|
Not understand what I could do, I don't think that I could buy a mini-usb connector and solder it to the main board, from the state you can see from my pic you think is it possible? P.S I don't understand what your pic means, the usb connector in my kobo is in the back of the mainboard, not in the front. Thank you!