Quote:
Originally Posted by Angemon
Light is acting weird in 2.10. I usually have it at 5% (1% is fine for text in darkness, but not enough for manga). My Aura HD went to sleep by itself and when i turned it back on the light was turned off (which is expected, the timer for both turning off the light and entering sleep mode is 15 minutes) but after turning the light back on it came at 1%. Turning off and on the light if it's less than 10% sends it back to 1%. I noticed on previous firmwares (2.6X, can't remember the exact number, it was the one it came with and 2.81) that if the light was over 1% and you turned it off you could see the light first dimmed to 1% before turning off, but it came back to whatever level it was set (5% in my case).
Doesn't happen when i put it to sleep manually, just when it goes to sleep for itself or when turning the light off and on, and only when the light is under 10%
|
Quote:
Originally Posted by KevinShort
I have the same bug on my Glo. Figures that with all the new stuff they added something had to break a little bit.  |
you can try setting the value in .kobo/Kobo/Kobo eReader.conf. After doing this, the value stayed even when turning light on and off on my Glo (interestingly, I didn't see this bug on my first try of the 2.10 firmware, after doing a factory reset I'm now again on 2.10 with this bug):
in your case, you might try