PDF to Mobi Conversion

[rayh]

When using Individual convert, on PDF Input screen Line Unwrapping Factor is 0.00 even though hover help claims iit is 0.45. If I set it to 0.45 then conversion of PDF to MOBI is pretty good, however I have to set it to 0.45 for each book. This problem also means that Bulk convert uses 0.00 for line unwrapping factor. Could this be fixed in next release, I am using latest.

Thanks
Ray

[DoctorOhh]

Originally Posted by rayh

When using Individual convert, on PDF Input screen Line Unwrapping Factor is 0.00 even though hover help claims iit is 0.45. If I set it to 0.45 then conversion of PDF to MOBI is pretty good, however I have to set it to 0.45 for each book. This problem also means that Bulk convert uses 0.00 for line unwrapping factor. Could this be fixed in next release, I am using latest.

It is already fixed. Go to Preferences - Conversion - Input options - PDF input - and ensure line unwrapping factor is set to 0.45. Now when you go to bulk convert it will use 0.45 unless you previously attempted a conversion on any of the books. To be safe ensure you uncheck the box in the top left corner of the bulk convert window (See attached).

When converting single books to be sure it is set to 0.45 check the PDF Input area, no where else (see attached).

Hover help had me confused, you are hovering over a grayed out (which means inactive) section in Structure detection. You set the line unwrapping factor for PDFs as stated above.

Of course if the above doesn't work maybe it is broke in this release.

[rayh]

Originally Posted by dwanthny

It is already fixed. Go to Preferences - Conversion - Input options - PDF input - and ensure line unwrapping factor is set to 0.45. Now when you go to bulk convert it will use 0.45 unless you previously attempted a conversion on any of the books. To be safe ensure you uncheck the box in the top left corner of the bulk convert window (See attached).

When converting single books to be sure it is set to 0.45 check the PDF Input area, no where else (see attached).

Hover help had me confused, you are hovering over a grayed out (which means inactive) section in Structure detection. You set the line unwrapping factor for PDFs as stated above.

Of course if the above doesn't work maybe it is broke in this release.

Thanks

I followed your instructions & all went well
Ray