Question about charging battery

smithno · 06-14-2009, 05:12 PM

Today, I loaded the OpenInkpotInstall20090326 firmware on my EZ Reader. I've been using LBook for a while because it uses CoolReader for HTML books, which I have because of format shifting anyway, and it does a good job. By the time I finished flashing it, the battery was below half. I plugged it in and the LED shows red as usual when I plug it in. With the other firmware, the LED shows green when it's fully charged. Does OI do the same thing??

Norm

idle · 06-14-2009, 05:47 PM

I think it does not. It always stays red for me when I charge it, even when it's on 100 %.

dottedmag · 06-17-2009, 06:14 AM

It's hardware limitation. V3 charging controller is quite stupid.

mvoosten · 06-17-2009, 11:12 AM

Quote:

Originally Posted by dottedmag

It's hardware limitation. V3 charging controller is quite stupid.

Ok.. but how come it turns green with the original firmware?
So it should be possible right?

dottedmag · 06-17-2009, 11:14 AM

It's possible, but useless. Red LED turns off when the charging is finished.

idle · 06-17-2009, 11:56 AM

So it *should* let you know when charging is done? Because mine stayed red, seemed like ages after it showed 100 %. Was I just too impatient?

dottedmag · 06-17-2009, 03:22 PM

Controller just charges battery several hours, and then stops. If you wait a bit longer, LED should turn off

06-14-2009, 05:12 PM	#1
smithno Groupie Posts: 152 Karma: 222484 Join Date: Jul 2008 Location: Tenn., US Device: jetBook, jetBook Lite, Kindle 3, Galaxy Note II	Question about charging battery Today, I loaded the OpenInkpotInstall20090326 firmware on my EZ Reader. I've been using LBook for a while because it uses CoolReader for HTML books, which I have because of format shifting anyway, and it does a good job. By the time I finished flashing it, the battery was below half. I plugged it in and the LED shows red as usual when I plug it in. With the other firmware, the LED shows green when it's fully charged. Does OI do the same thing?? Norm

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PRS-300 Battery Charging	MikeRo	Sony Reader	5	02-14-2010 04:33 PM
battery charging help	1miki23	Astak EZReader	4	02-11-2010 02:22 PM
Battery Charging	UchihaNaru	Astak EZReader	11	10-02-2009 10:25 PM
Question about charging the battery	artemisblossom	Sony Reader	10	05-31-2009 11:37 AM
Battery charging question	Aprilbeginnings	Sony Reader	13	11-21-2006 05:10 PM

06-14-2009, 05:47 PM	#2
idle I Do Like Ebooks Posts: 145 Karma: 1006 Join Date: May 2009 Location: Prague, Czech rep. Device: Pocketbook Ultra 650	I think it does not. It always stays red for me when I charge it, even when it's on 100 %.

06-17-2009, 06:14 AM	#3
dottedmag OpenInkpot co-founder Posts: 410 Karma: 845 Join Date: Dec 2007 Device: Kindle Oasis	It's hardware limitation. V3 charging controller is quite stupid.

06-17-2009, 11:14 AM	#5
dottedmag OpenInkpot co-founder Posts: 410 Karma: 845 Join Date: Dec 2007 Device: Kindle Oasis	It's possible, but useless. Red LED turns off when the charging is finished.

06-17-2009, 11:56 AM	#6
idle I Do Like Ebooks Posts: 145 Karma: 1006 Join Date: May 2009 Location: Prague, Czech rep. Device: Pocketbook Ultra 650	So it should let you know when charging is done? Because mine stayed red, seemed like ages after it showed 100 %. Was I just too impatient?

06-17-2009, 03:22 PM	#7
dottedmag OpenInkpot co-founder Posts: 410 Karma: 845 Join Date: Dec 2007 Device: Kindle Oasis	Controller just charges battery several hours, and then stops. If you wait a bit longer, LED should turn off

Advert

Advert