11-16-2019, 02:28 AM | #1 |
Member
Posts: 19
Karma: 10
Join Date: Oct 2019
Location: AU
Device: Kobo Clara BW, Kindle Paperwhite 10th
|
Should I trust the waterproofing on water-safe Kobos?
Hi all,
After watching a few videos of the Aura H20 (and it's newer sibling Aura H20 Edition 2) in the water, I have come to a conclusion that they employ different waterproofing techniques. While the OG uses flaps and water-resistant tape to seal the device from water, the Edition 2 H2O just relies on HZO Protection nanocoating, which basically means there is (theorotically) no effort to seal the innards from water. Since I'm living in a tropical country, I'm looking forward to upgrading to an ereader that's not shy of water. So from your experience, are the nanocoating waterproofed Kobos more reliable in terms of long-term waterproofing compared to the old-but-trusty flaps and tape on the older Aura H2O? And what to do with the exposed USB port on the H2O Edition 2 when it's wet? Does the H2O Edition 2 warn of water is present in the port? Do note that I can get either one brand-new, with the H2O Edition 2 being marginally more expensive. I do not care much about ComfortLight Pro or the extra storage. Thanks in advance. Tldr: should I trust the HZO Protected Kobos in tropical conditions? |
11-16-2019, 02:36 AM | #2 |
Wizard
Posts: 2,851
Karma: 22003124
Join Date: Aug 2014
Device: Kobo Forma, Kobo Sage, Kobo Libra 2
|
I can put both the original H2O, the Kobo Aura One, and the Forma underwater and they work fine on removal.
Do I suggest constantly keeping them submerged? No. But atmospheric water should be ok, just make some effort to make sure they aren't swimming all the time. |
Advert | |
|
11-16-2019, 09:36 AM | #3 |
Linux User
Posts: 2,279
Karma: 6123806
Join Date: Sep 2010
Location: Heidelberg, Germany
Device: none
|
I don't trust it at all.
The coating has gaps in it (as far as I could tell when opening my Kindle Paperwhite 4), and if water got in it'd probably leave residue and whatnot. Not to mention it would take ages to dry. The original H2O water seal breaks easily (happened to my mother's H2O when snapping it into Fintie case, the front bezel was lifted off in one corner) and for the flap it's hard to tell whether it's closed properly. There may also be long term effects, a German reviewer (allesebook) put their H2O in the freezer and it was fine afterwards, until it stopped working half a year later due to rusted contacts inside. Water and electronics just doesn't mix. So, I keep my devices away from water. If in doubt, bring a ziploc bag or similar. That said, some people manage to drown their non-waterproof devices and have them survive regardless (after removing battery and allowing to dry for a week). So maybe having even just a little protection is already considered enough in most cases? Even so, I just don't trust it. And if I could choose between a waterproof device and one with microsd slot, I'd always go for the microsd... user-replaceable storage is super useful (especially if you're into modding), waterproof is just a gimmick... |
11-16-2019, 12:41 PM | #4 |
the rook, bossing Never.
Posts: 12,268
Karma: 89531599
Join Date: Jun 2017
Location: Ireland
Device: All 4 Kinds: epub eink, Kindle, android eink, NxtPaper11
|
Despite the name the coating concept is essentially 1940s "tropicalization".
It's better than not having it and means an accident is less likely to be terminal for the gadget. I'd be very surprised if there are not fractures in the coating with age. I'd risk reading in the bath but assume it might not survive being dropped in. |
11-16-2019, 01:20 PM | #5 |
Groupie
Posts: 176
Karma: 1834850
Join Date: May 2011
Location: UK
Device: Sony PRS-300, Sony PRS- T3S, Kobo aura H2O Kobo aura One Kobo libra
|
I read in the shower/bath & have done so with my original H2O, KAO and now the libra. Have had no problems with any of them so far, though they have never been submerged for a significant period of time. I do take care to make sure the reader is dry & sufficient time has passed to allow the USB port to be clear of water before charging.
|
Advert | |
|
11-16-2019, 01:51 PM | #6 |
Wizard
Posts: 1,215
Karma: 5372649
Join Date: Jun 2011
Location: Ontario, Canada
Device: Kobo Aura HD
|
The HZO laquer is much better protection than the original H20 model. That one was subject to 'user' error every time the flap is opened, (is it sealed properly every time?). The flap would break off with use unless you were super careful, and as pointed out, it offered no protection from moisture introduced by condensation.
I've gleefully submerged all my water-proof e-readers multiple times.. that being said, I would not be stressed out if one suffered a misadventure. |
11-16-2019, 03:40 PM | #7 |
the rook, bossing Never.
Posts: 12,268
Karma: 89531599
Join Date: Jun 2017
Location: Ireland
Device: All 4 Kinds: epub eink, Kindle, android eink, NxtPaper11
|
As expected, a zip-lock bag works perfectly (possibly BETTER) on the capacitive Libra, but only taps (and not always) on the original Aura H2O.
The HZO lacquer can't be trusted. Also if the USB connector is wet you may get electrochemical corrosion of the body of a plug. Long term you could get PCB corrosion via the USB connector. Gold doesn't corrode at all. But in any damp situation every other non-noble metal will have accelerated corrosion. That's why gold plated audio connectors are madness on any regular nickel or tin or chromed socket on equipment, or even near a damp connector. The rule is only gold to gold. Also how thick is the gold plating on the USB connector? Most consumer connectors have too thin. Ironically impure gold lasts better. Purest gold is softest. Electrum is a pretty ancient alloy of gold, silver and copper. Still used as it's much harder. Alloys with other noble metals are good too. While the rubber bung on the original H2O could wear out or break off, a sealed case is a far better idea than a coated PCB. How reliable will the coating be for display connector interfaces? A screw on watch back with an inset neoprene ring is reliable. The original H2O was not. It relied on double sided sticky tape in one piece to stop water getting in at the screen (which meant a gap for dust) and at the outer edge of the bezel which wasn't inset to case so it could catch. Some have been poorly assembled and had a gap on the outer edge. Add a zip bag if on the beach, pool, camping or in the bath. Even if the HZO coating works today, it will fail. The exposed USB and gap at the buttons on the Libra is mad. Blow in at the USB and feel air come out at the buttons. I didn't trust the original Aura H2O which cost me €220 at the beginning; it's certainly not trustworthy now. I'll not trust the Kobo Libra H2O either. Less so, as it's impossible to visually gauge any degradation. They (HZO call it "nanotechnology". So is two part polyurethane varnish*, which will waterproof a circuit board). Independent Figures for how good HZO is on something with connectors and degradation with time that are independent tests? The awards received say nothing about the goodness of the technology, but about marketing. This is an 80 year old concept. (*The Polyurethane eventually develops cracks. Wax was used 1830s to 1950s, think something closer to Vaseline than candle wax so it does crack. Water amazing does dissolve in it (and in paraffin, diesel, jet fuel etc) so after 8 to 12 years protected parts and wiring start to corrode. In the 1940s military gear switched to a mix of hermetic sealing and special varnishes.) I'd be very upset to lose €180 worth of Kobo Libra H2O due to a dunking. Last edited by Quoth; 11-16-2019 at 03:43 PM. Reason: Consequences |
11-16-2019, 08:08 PM | #8 |
Member
Posts: 19
Karma: 10
Join Date: Oct 2019
Location: AU
Device: Kobo Clara BW, Kindle Paperwhite 10th
|
Thanks for all the insightful replies. So I assume neither waterproofing methods truly work? If so I might get a Paperwhite 4, since Amazon support is great with these issues.
Also, I watched a disassembly of the Paperwhite 4 and there is absolutely no seal between the back cover and all the electronics inside, so is the waterproofing technique there similar to HZO? I don't see it being mentioned anywhere. |
11-16-2019, 08:12 PM | #9 |
Member
Posts: 19
Karma: 10
Join Date: Oct 2019
Location: AU
Device: Kobo Clara BW, Kindle Paperwhite 10th
|
Also, a video from HZO themselves claim the coating is permanent. I doubt it now...
|
11-16-2019, 10:14 PM | #10 |
Grand Sorcerer
Posts: 24,905
Karma: 47303822
Join Date: Jul 2011
Location: Sydney, Australia
Device: Kobo:Touch,Glo, AuraH2O, GloHD,AuraONE, ClaraHD, Libra H2O; tolinoepos
|
@jkelol111: I can't work out why you have come to this conclusion. There are no reports above of failures in the current waterproofing method. This method has been around for a number of years for other devices, and other than the pessimism expressed above, there is no reason to think it is no good.
For the two actual failures reported, they are for the original Aura H2O. One is after the device was put in a freezer, which will means it was exposed to a temperature outside Kobo's recommended storage temperatures. That might have caused the later failure of the seals. The other is a failure during handling that shouldn't have happened. I won't deny I always hesitate before taking my devices out of their covers as I'm always worried I'll twist it and damage the screen. Overall, there have been very few reports of failures of the waterproofing of the original Aura H2O here. And, I cannot think of a single report for the HZO treated devices. I haven't searched elsewhere, but, I would expect to see them linked to here if there was a problem. |
11-17-2019, 05:26 AM | #11 |
the rook, bossing Never.
Posts: 12,268
Karma: 89531599
Join Date: Jun 2017
Location: Ireland
Device: All 4 Kinds: epub eink, Kindle, android eink, NxtPaper11
|
It's too new to say if reliable, and where is any independent audit?
Also reports on a website are a small proportion of failures for anything, in general. Or they can be the reverse, some feature blown out of proportion. Obviously if a product is completely terrible that's quite obvious. |
11-17-2019, 10:23 AM | #12 |
Guru
Posts: 738
Karma: 7025494
Join Date: Aug 2017
Location: Italy
Device: Kindle Paperwhite, Kobo Elipsa, Pocketbook Inkpad 4, Inkpad Color
|
I agree with Davidfor: I washed my Kobo Aura One and I had no problem. I don't think that rain, even in a tropical country, could be more dangerous than putting it under tap water.
Last edited by ps67; 11-17-2019 at 10:37 AM. |
11-17-2019, 10:31 AM | #13 |
Wizard
Posts: 2,454
Karma: 5469320
Join Date: Jul 2010
Device: Kobo
|
I'm with Davidfor. Doing a quick internet search doesn't throw up any results of failure. Are there going to be some? Sure. Nothing is 100% perfect, but since there doesn't seem to be many reports of HZO failure I'm guessing it's pretty good. Yes it's good to be skeptical of the marketing claims for something like this, but "similar" to a 70's product isn't the same.
|
11-17-2019, 11:03 AM | #14 |
Gentleman and scholar
Posts: 11,272
Karma: 110227191
Join Date: Jun 2015
Location: Space City, Texas
Device: Clara HD; Nook ST w/Glowlight, (2015) Glowlight Plus, Paperwhite 3
|
|
11-17-2019, 11:21 AM | #15 |
Linux User
Posts: 2,279
Karma: 6123806
Join Date: Sep 2010
Location: Heidelberg, Germany
Device: none
|
|
Tags |
aura h2o, aura h2o v2, water |
Thread Tools | Search this Thread |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Safe way to update older Kobos? | rcentros | Kobo Reader | 7 | 09-12-2019 03:32 AM |
EuGH zu Safe Haven USA: Not safe enough. | beachwanderer | Deutsches Forum | 0 | 10-06-2015 04:25 AM |
Waterproofing your ebook reader | RickyMaveety | Lounge | 7 | 05-09-2011 04:01 PM |