PW3 Kindle PW3 5.9.4 Jailbreak

[apexury]

Originally Posted by encryptedcypher

Thankfully on the otherside of the board, pins TM800 and TM801 are the same RX and TX connections. I still had to solder in the ground cable to the ground on the serial port connection to make this work.

Also, I WAS able to install the Kual booklet successfully and also install the backdoorlock using the KUAL installer. (To prevent Amazon from auto upgrading the firmware).

I would be happy to provide pictures if anyone wants to see how I soldered the connections.

Hi, encryptedcypher, I have the same questions in soldering as you, and I found TM800 and TM801 on the otherside of the motherboard,

BUT I found them have some difference as RX and TX while I use multimeter to check them...I found they are little bit weird in resistance.

If you were successfully jailbreak your device as you describe, I would like to see your soldering before I begin my jailbreak using TM800 and TM801.

By the way, my device is KPW3, email me if it possible(because I have some problem in open this forum sometimse...)martinhsiao@outlook.com, thx.