Register Guidelines E-Books Today's Posts Search

Go Back   MobileRead Forums > E-Book Readers > More E-Book Readers > iRex

Notices

Reply
 
Thread Tools Search this Thread
Old 10-16-2010, 08:24 AM   #1
bokjeid
Addict
bokjeid began at the beginning.
 
Posts: 217
Karma: 10
Join Date: May 2010
Device: DR1000S
My brand new DR1000S don't turn on

I bought a wall charger(1500mAh-5V as mentioned at my other thread) and charged my brand new DR1000S for about 10 hours but it don't turn on yet.. Even with no light on the device.
As for DR800SG, I had a similar experience but finally its light and it turned on after many hours charging.
Should I do charge for more hours? How many hours will be enough for it? I'll post the process after all night long charging.
Please tell me your experience or informations about this..
bokjeid is offline   Reply With Quote
Old 10-16-2010, 08:37 AM   #2
tjdean256
Zealot
tjdean256 is on a distinguished road
 
Posts: 138
Karma: 70
Join Date: Jan 2009
Location: Louisiana
Device: irex dr1000s; Pocket edge
bokjeid,

I have certainly bought a couple of worthless chargers. I cut the wire of one and found out that it was only producing 2V despite a stated rating of 5V. If oyou charge it from the USB port of the desktop make sure you are using a ver 2.0 USB. Version 1 doesn't provide power. I use a old Motorola phone charger. The Belkin charger for an iPhone works well too. I has a USB connection into the charger that I change out to the mini-USB cord. I could also charge the DR with an HTC tilt phone charger, but couldn't run the device with it. Hope something works for you.

td
tjdean256 is offline   Reply With Quote
Advert
Old 10-16-2010, 09:21 AM   #3
bokjeid
Addict
bokjeid began at the beginning.
 
Posts: 217
Karma: 10
Join Date: May 2010
Device: DR1000S
Quote:
Originally Posted by tjdean256 View Post
bokjeid,

I have certainly bought a couple of worthless chargers. I cut the wire of one and found out that it was only producing 2V despite a stated rating of 5V. If oyou charge it from the USB port of the desktop make sure you are using a ver 2.0 USB. Version 1 doesn't provide power. I use a old Motorola phone charger. The Belkin charger for an iPhone works well too. I has a USB connection into the charger that I change out to the mini-USB cord. I could also charge the DR with an HTC tilt phone charger, but couldn't run the device with it. Hope something works for you.

td
Thank you for your immediate reply, td.
For my device, I bought a somewhat expensive wall charger which says it guarantee its voltage and currency.. Although its surfacial condition was so dirty but it may have no problem usually.. And my device wasn't turned on at the first time and its light, either since I got it. This seems the point of the problem. Its battery seems dead or half-dead just like my last DR800SG's - the Li-ion battery shouldn't be discharged at all for a long time, you know.
Therefore, in my view, changing or reviving the battery will be the solution to this problem.. I'd like to leave changing the battery as my last card.
So, how can I revive the battery?
bokjeid is offline   Reply With Quote
Old 10-16-2010, 03:09 PM   #4
Mackx
Guru
Mackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to beholdMackx is a splendid one to behold
 
Posts: 999
Karma: 19985
Join Date: Dec 2008
Location: Netherlands
Device: iRex DR1000S
I heared before that a device would not start after is was fully charged from completely empty, as if the battery-controller is somewhat 'confused'. After leaving the device for a few hours to discharge a little the device started again. Maybe that is also your problem. Try to start it in a few hours or tomorrow.
Mackx is offline   Reply With Quote
Old 10-16-2010, 05:36 PM   #5
bokjeid
Addict
bokjeid began at the beginning.
 
Posts: 217
Karma: 10
Join Date: May 2010
Device: DR1000S
Quote:
Originally Posted by Mackx View Post
I heared before that a device would not start after is was fully charged from completely empty, as if the battery-controller is somewhat 'confused'. After leaving the device for a few hours to discharge a little the device started again. Maybe that is also your problem. Try to start it in a few hours or tomorrow.
Thank you for your answer, Mackx. I'll try this now.. It is what I'm worried about that there has been no light of the device all the time although I was charging it for many hours, about 18 hours until now.. Is there some posibility that the battery had died utterly?;;

Last edited by bokjeid; 10-16-2010 at 05:40 PM. Reason: added a little
bokjeid is offline   Reply With Quote
Advert
Old 10-16-2010, 06:31 PM   #6
bokjeid
Addict
bokjeid began at the beginning.
 
Posts: 217
Karma: 10
Join Date: May 2010
Device: DR1000S
Ah, I flashed into the 'reset' hole and saw that the reset button isn't there - it should have gone away. So I have to open the device and make it repaired. There is a famous mechanic shop to change battery of DR1000S in my country. I'll visit there tomorrow and post the result here.. I could never guess the reset button disappeared;
bokjeid is offline   Reply With Quote
Old 10-22-2010, 11:50 PM   #7
joblack
Wizard
joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.joblack ought to be getting tired of karma fortunes by now.
 
Posts: 1,751
Karma: 4382688
Join Date: Jul 2006
Location: Somewhere on earth
Device: Onyx Boox Tab X C
Quote:
Originally Posted by bokjeid View Post
I bought a wall charger(1500mAh-5V as mentioned at my other thread) and charged my brand new DR1000S for about 10 hours but it don't turn on yet.. Even with no light on the device.
As for DR800SG, I had a similar experience but finally its light and it turned on after many hours charging.
Should I do charge for more hours? How many hours will be enough for it? I'll post the process after all night long charging.
Please tell me your experience or informations about this..
Where did you get a brand new 1000s?
joblack is offline   Reply With Quote
Old 10-23-2010, 04:02 AM   #8
bokjeid
Addict
bokjeid began at the beginning.
 
Posts: 217
Karma: 10
Join Date: May 2010
Device: DR1000S
Quote:
Originally Posted by joblack View Post
Where did you get a brand new 1000s?
An local retailer's last one stock - much time did I spend to find it out.
bokjeid is offline   Reply With Quote
Reply


Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Ended DR1000S planetrobbie Flea Market 1 04-17-2009 04:05 AM
Brand new 700... with brand new problems! :S ozk Sony Reader 6 02-28-2009 08:40 PM
What to to/install on a brand new DR1000S yolle iRex 4 12-24-2008 11:52 PM
Please help. Brand new and it won't turn on Sharone Bookeen 33 05-01-2008 08:01 PM


All times are GMT -4. The time now is 10:07 PM.


MobileRead.com is a privately owned, operated and funded community.