Error with check library, out of memory

zardoxnet · 04-09-2026, 11:12 PM

MacOS (Latest)
Calibre 9.6
menu
_Calibre_master -> Library Maintenance -> Check Library

when running it gives an error that the system has run out of memory. I need to force quit.

It seems there is adequate storage 10gb on hard drive. No other application open. I have reboot and attempted several times.

Any help? I did not yet submit as a bug as this may only be on my system.

zardoxnet · 04-12-2026, 10:59 PM

With Calibre 9.7.0 this is somewhat better, though not entirely fixed. I initiate "Check Library" then OK to "Check the database file". It runs for short while (30 seconds perhaps) and I get a success message. Then I get the usual "Check library -- Problems found" dialog and I click done. That seems as it was before. HOWEVER. A spinning MacOS icon is shown for about a minute before it is completed and Calibre released for further use -- I don't think it was like that before. Its ok then, doesn't cause crash, just a delay after running.

04-09-2026, 11:12 PM	#1
zardoxnet Junior Member Posts: 6 Karma: 10 Join Date: Dec 2016 Device: android phone	Error with check library, out of memory MacOS (Latest) Calibre 9.6 menu _Calibre_master -> Library Maintenance -> Check Library when running it gives an error that the system has run out of memory. I need to force quit. It seems there is adequate storage 10gb on hard drive. No other application open. I have reboot and attempted several times. Any help? I did not yet submit as a bug as this may only be on my system.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Check Library Error	kstar	Library Management	3	03-18-2023 02:00 PM
Library Maintenance - Check Library Error	ampws	Library Management	5	06-07-2020 06:10 AM
1.1.0 - Check Library Error	nynaevelan	Calibre	2	08-31-2013 02:33 AM
Extra Titles Error Persists in Check Library	GeekyGal	Library Management	2	12-10-2011 10:13 AM
Check Library Error	nynaevelan	Calibre	2	06-05-2011 11:41 AM

04-12-2026, 10:59 PM	#2
zardoxnet Junior Member Posts: 6 Karma: 10 Join Date: Dec 2016 Device: android phone	With Calibre 9.7.0 this is somewhat better, though not entirely fixed. I initiate "Check Library" then OK to "Check the database file". It runs for short while (30 seconds perhaps) and I get a success message. Then I get the usual "Check library -- Problems found" dialog and I click done. That seems as it was before. HOWEVER. A spinning MacOS icon is shown for about a minute before it is completed and Calibre released for further use -- I don't think it was like that before. Its ok then, doesn't cause crash, just a delay after running.