MobileRead Forums - View Single Post

IndecisiveMe · 05-31-2010, 01:26 AM

I've just installed the new firmware and made sure I read through the "how to install new firmware" thread first.

I copied the unpacked update file to my card, turned off my reader, held the center and upper page turn buttons at the same time I turned the reader back on. I did not let got of either button until it told me the update was successful.

The reader then restart itself after telling me to press the center button. I DID NOT need to press the center button for it to restart, it restarted before I even let go of the button.

When I went in to check if the firmware had updated, my reader still shows that I'm using the 14.2 firmware.

How is that possible, and what did I do wrong?

I also made sure I had no old firmware updates on my card or reader. I'm baffled.

05-31-2010, 01:26 AM	#1
IndecisiveMe Addict Posts: 276 Karma: 106 Join Date: Jan 2010 Location: Melbourne, Australia Device: Pocketbook 360, Sony PRS-T1	Problem installing new firmware. I've just installed the new firmware and made sure I read through the "how to install new firmware" thread first. I copied the unpacked update file to my card, turned off my reader, held the center and upper page turn buttons at the same time I turned the reader back on. I did not let got of either button until it told me the update was successful. The reader then restart itself after telling me to press the center button. I DID NOT need to press the center button for it to restart, it restarted before I even let go of the button. When I went in to check if the firmware had updated, my reader still shows that I'm using the 14.2 firmware. How is that possible, and what did I do wrong? I also made sure I had no old firmware updates on my card or reader. I'm baffled.