Karen
Installation of PRS+ on a 600 is a two (2) step process!
First you need to "unlock" the reader by installing a base-image.
Instructions taken from the project site.
Spoiler:
600
1. "Unlock" your reader using "PRSP 600 base flasher by amutin" (use the latest version) (check "installing base image" below) SKIP THIS STEP IF YOU ALREADY HAVE BASE FLASH. You need to do this step only once (it won't do harm if you do it twice, but it simply makes no sense)
Installing base image (needed by 600)
1. Vista/Win7 users: disable UAC (read here how to
http://www.howtogeek.com/howto/windo...-command-line/ )
2. Connect your PRS 600 to your PC
3. run runme.bat
4. Sony's standard flasher UI will show up (that's why you need to disable UAC, this installer modifies Sony's, to install custom image)
5. Follow instructions on the screen.
6. Don't forget to restore UAC
The content of "PRS-600_base_flasher_1.0_by_amutin.zip" should be in a folder of your PC, not the reader!
Try running runme.bat form the folder on PC with the device connected to the USB- Port.
Hopefully your PRS-600 is still in firmware-update mode and will accept the new firmware.
Good luck!!
Then procced to step 2 of the instruction:
PS: plugging in a wall-charger to keep it alive may also be a good idea.
PPS: you can also try the sony-updater
PRS-600_Updater_1.0.01.08040.exe to recover your reader