MobileRead Forums - View Single Post - Firmware Upgrade

rodalton · 12-04-2008, 11:01 PM

Hello all,

I hope this is not a question commonly asked. I searched around but did not find anything.

I have a new Hanlin V3 with V2.00EN firmware. I downloaded the V2.01 began the upgrade. It upgraded the kernel and is stuck at step 2, update system. The device is plugged in (and full charge) and the bar at the bottom is not moving at all (about 25% complete). I don't really wish to turn it off and back on - not sure what results I'll have. It's been sitting here for about 15 minutes.

any suggestions?

Thanks

12-04-2008, 11:01 PM	#1
rodalton Junior Member Posts: 2 Karma: 10 Join Date: Dec 2008 Device: EZ Reader/Hanlin V3	Firmware Upgrade - How long? Hello all, I hope this is not a question commonly asked. I searched around but did not find anything. I have a new Hanlin V3 with V2.00EN firmware. I downloaded the V2.01 began the upgrade. It upgraded the kernel and is stuck at step 2, update system. The device is plugged in (and full charge) and the bar at the bottom is not moving at all (about 25% complete). I don't really wish to turn it off and back on - not sure what results I'll have. It's been sitting here for about 15 minutes. any suggestions? Thanks