Hi Lunohod:
By V3 do you mean directory where the build is or the EReader? If it is the EReader, how do I set the DISPLAY variable?
Also when I ran the Build-FW and flashed into my eReader, I get only the GM (Global Menu) screen. There is no other apps installed. I ran all the commands as provided in
http://openinkpot.org/wiki/From0To60In5Seconds
Not sure where I am making mistake. Also all the packages I got as source were only for GM. Not sure again on where I would have MadShelf package, and how to install / build in the firmware!
Another thing that is bugging me is Build-FW goes and collects information from web all the time. I want to do this off line and since rootfs-armel is created (I can see it) can I run the Build-FW offline?
If so what command do I use?
Your help would be greatly appreciated.
Thanks
Vasu