|
Thanks for the response. Both drives are internal on an IDE bus. The current library folder has been created in the Home folder, and I have rights to it. I can't browser outside the Home folder in Calibre. If I raise the level to Computer during the Switch Library dialog, no folders but Home are shown.
I can access the second drive with other software, just not with Calibre. The result from a Mount command are below.
/dev/loop0 on / type ext3 (rw)
proc on /proc type proc (rw,noexec,nosuid,nodev)
sysfs on /sys type sysfs (rw,noexec,nosuid,nodev)
none on /sys/fs/fuse/connections type fusectl (rw)
none on /sys/kernel/debug type debugfs (rw)
none on /sys/kernel/security type securityfs (rw)
udev on /dev type devtmpfs (rw,mode=0755)
devpts on /dev/pts type devpts (rw,noexec,nosuid,gid=5,mode=0620)
tmpfs on /run type tmpfs (rw,noexec,nosuid,size=10%,mode=0755)
none on /run/lock type tmpfs (rw,noexec,nosuid,nodev,size=5242880)
none on /run/shm type tmpfs (rw,nosuid,nodev)
/dev/sda1 on /host type fuseblk (rw,nosuid,nodev,relatime,user_id=0,group_id=0,all ow_other,blksize=4096)
gvfs-fuse-daemon on /home/admin/.gvfs type fuse.gvfs-fuse-daemon (rw,nosuid,nodev,user=admin)
|