Well, with these settings:
usage:
./tones -f 4000 -D hw -c 2 -v -r16000 -mdirect_write
and
zcat gmvid.gmv.gz | ./gmplay-1.5a
It is possible to get the two halves to run - happily - on the kindle 3 - without dying.
Now, to get some audio piped through it... any thoughts on how best to "interleave / stream / load / whatever " the data out of ffmpeg? I suppose I better go dig up a man page.
I'm looking for RAW data with ideally RAW wav data strapped to it in some sensible fashion. or at worst something I can decode without trampling on someones IP.
I think I could manage ac3 for example. I think.
Anyways thought I would report the extremely low cpu usage in that mode.
I'll see about getting something other than a stupidly modulated sine out of the demo.
Thanks GM