Hello JPA,
My Reader stopped to work after 10years. It is blocked on Opening book...
I tryed a lot of solution, but I can reach only recovery console with serial using rupor-rescue on my SD Card.
If I try to make a backup of my PRS-T1 with DD, I receive Input/output error on dev/mmcblk2.
dd if=/dev/mmcblk2 of=/dev/null skip=119000 count=2000
dd: /dev/mmcblk2: Input/output error
So, after reading your posts, I prepared my 8gB SD card with your PRS-T1 1.0.07 image. I don't touch anything else on SD card.
Quote:
|
sudo dd if=sd_card_PRS-T1_1.0.07_adb_enabled.bin of=/dev/rdisk2 bs=1m
|
Then I tried to boot my PRS-T1 on recovery mode (HOME + MENU), it reach 100%, but restart.
So I don't undestand exactly how to use your premade image and exactly wich are the instructions to change the uboot configuration.
I'm using MacOS.