|
The updates work like this:
"If you are registered to iDS you can skip this step and immediately connect to iDS to receive the latest software release. Due to the size of this release the download and installation will be done in two steps. After the successful installation of the first part you will need to reconnect to iDS again to download and install the second part.
(Note: Make sure that your iLiad is fully charged or connected to the power plug before starting the download.)
Connect to iDS by pressing the connect key of your iLiad for 2 seconds.
After the download your iLiad will shut itself down which can take up to 15 seconds.
When the screen turns white and the led goes out you can turn on your iLiad again and the installation of the new software release will automatically start.
After the new software has been installed you will need to restart your iLiad.
(Caution: Please make sure the iLiad does not run out of power while the new software is being installed. If the device runs out of power at this stage it may be programmed with incomplete software, rendering it unusable.)"
Taken from the email they sent today.
|