View Single Post
Old 10-11-2011, 12:19 AM   #88
nikkie
Guru
nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40nikkie is slicker than a case of WD-40
 
nikkie's Avatar
 
Posts: 614
Karma: 73700
Join Date: Oct 2009
Location: WA, USA
Device: Android, Kindle Paperwhite, lots of ancient readers
IT'S ALIVE!!!!!!!!!!!!!!!!!!!

*dances a jig*

Okay, So...toyz, I'm guessing you didn't watch while the flashing procedure was attempting to commence. In mine, the log indicated that there was a version mismatch since I was trying to flash a device that currently identified itself as an edge with the edgejr image. So, I downloaded the version of the firmware (Dingo) for the Pocket Edge that has the version commented out, slapped that on the usb drive, and ran run boot_user. It took, and my device was then working.

Next, I updated to Ermine, and it took fine. So, sweet. *dances another jig*

For those interested, here's what's necessary:

Either
1) a motherboard with serial support or
2) a USB to Serial cable such as this one

And
3) a Serial cord that you don't mind chopping the end off. We used a $6 cable from vetco.
4) 3 bricks worth of header from sparkfun

To make the cable - chop the male end of the db9 cable (the one that doesn't fit into the usb to serial cable), and solder it to the header per the pin diagrams shown in the pics linked below, which for us was Red Brown Yellow - if you bought the same cables I did - otherwise you need a multimeter or some such to figure it out.

Then for Windows 7, download Termite. Get your keyboard ready, and as soon as you've hit the boot button, start typing keys until the uboot prompt comes up. Use the settings in Envos post, except the parity bit should be NONE instead of odd.

Then in Termite, type

Quote:
run boot_user
It will flash with whatever thing you've plugged in, in my case to the usb, (don't try and use a microSD card with the case open). If you have previously accidentally flashed with the edge firmware instead of the edgejr firmware, you should download the firmware from darkgrue's thread FOR YOUR DEVICE and flash with that. I see no reason not to make the same change to an Ermine rom, I just haven't done it yet.

Pics of the process and cabling are available here on flickr.

Gotchas: I couldn't get the serial usb dongle to work on OSX Lion, which is why I ended up doing it in Windows. You might find differently.

Last edited by nikkie; 10-11-2011 at 01:01 AM.
nikkie is offline   Reply With Quote