MobileRead Forums - View Single Post - PRS-505 Downgrading european 505's to US firmware

PJ45 · 07-04-2009, 09:06 AM

Dpieron, I am still trying to figure it out, my version is 1.1.01.25200 but I think its the same problem since it is higher than the sony update 1.1.0.18040.
I am trying the run the PRSCustomizer version 1.0.0..
I tried your trick as explain above but it still does not work. (runig software give my a grey square windows instead.

I understand your are replacing the full line with the same end of it ? so it's the same as erasing the begining << { this.checkmark.show(true) this.button.enable(false) this.container.setVariable("updateStatus", "This PRS-505 is up-to-date") } >> isn't it? or should I keep the sign " {... } ' ???
this is what I replaced the whole you mentioned line with:
if (this.compareDeviceVersion(version)) {(this.checkmark.show(false) this.button.enable(true) this.container.setVariable("updateStatus", "Please click below to continue") }

07-04-2009, 09:06 AM	#7
PJ45 Member Posts: 20 Karma: 10 Join Date: Jun 2009 Device: Frs 505	Dpieron, I am still trying to figure it out, my version is 1.1.01.25200 but I think its the same problem since it is higher than the sony update 1.1.0.18040. I am trying the run the PRSCustomizer version 1.0.0.. I tried your trick as explain above but it still does not work. (runig software give my a grey square windows instead. I understand your are replacing the full line with the same end of it ? so it's the same as erasing the begining << { this.checkmark.show(true) this.button.enable(false) this.container.setVariable("updateStatus", "This PRS-505 is up-to-date") } >> isn't it? or should I keep the sign " {... } ' ??? this is what I replaced the whole you mentioned line with: if (this.compareDeviceVersion(version)) {(this.checkmark.show(false) this.button.enable(true) this.container.setVariable("updateStatus", "Please click below to continue") }