Hi, everyone. How could I boot into diagnostic mode when KT updated to 5.3.2, except the mfg tool?
I found this:
Code:
# idme -h
usage: idme <ARGUMENTS>
--serial S Sets the serial number S
--board B Sets the board id B
--pcbsn PCB Sets the pcb serial number PCB
--mac M Sets the MAC address M
--mfg ID Sets the Manufacturer Code
--bootmode BM Sets the bootmode value
--postmode PM Sets the postmode value
? Shows all existing values
So could
Code:
# idme --postmode ...(some mode name here?)
do this after reboot when I ssh into the KT in main mode?
Thank you!