[T.J.]

Hello everyone,

I have a Bebook Neo, which I have used a lot. The few issues Ivw had with it in the past, Ive been able to solve.
However, this time, no matter what I have tried, I cant solve this problem.

I had finished reading an e-book and was going to select another, which was on another SD-card. I changed cards,the proper way (removing card via the menu before switching it) When I had switched, the Neo didn't show any content on the card, and when trying another one it suddenly showed the contents of the previous one. I tried swapping cards a few times, and after a few attempts, it was showing the correct information. So far so good.

I thought everything was well, but then the Neo turned off all of a sudden in the middle of my reading. but not quite. You see, after it had stated that it was turning off, the screen wwent blank as it does when turning off. This time though, the little indicator light which is psitioned above "menu" and below the screen, didn't turn off. I cant start it, unless I use the reset button located on the back of the device. Nevertheless, it turns off after its been on a few minutes.

I have the last update of the firmware that I know of the Aug2011, one.
I attempted to run the firmware update again, but either I'm doing it wrong, or the Neo doesn't accept this action, due to it not turning off completely.

I'd be very grateful if someone here could please help me to solve this, since I do find the Neo very good and I have loved it from the start.

Thanks in advance.

I'll make sure of sticking around and help others if I can. Been a member before, ánd enjoyed the community a lot.

/T