View Single Post
Old 02-14-2013, 01:04 PM   #51
korendian began at the beginning.
Posts: 2
Karma: 10
Join Date: Feb 2013
Device: boox m92
Originally Posted by pkbo View Post
Initially CR was designed to select margins from a set of predefined values. In the onyx lunohod have implemented dialog allowing to enter arbitrary value for margins but he did not change CR engine to accept such arbitrary values. Most likely you enter value which is not supported by the engine so it reverts back to the default one. Here is the list of supported values:
0, 1, 2, 3, 4, 5, 8, 10, 12, 14, 15, 16, 20, 25, 30, 40, 50, 60, 80, 100, 130
Please try some value from the above list and let me know if it remembered when CR restarts.
Those values seem to have worked fine. Thank you very much.
korendian is offline   Reply With Quote