View Single Post
Old 07-07-2019, 12:30 PM   #3
rvcjew
Addict
rvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankindrvcjew has exceeded all limitations known to mankind
 
rvcjew's Avatar
 
Posts: 250
Karma: 17266
Join Date: Nov 2017
Location: USA,CA
Device: PW3, T80S, T80D, T103D, Ares Note
How far off is it from center? Are you sure your tip is all the way in? The Wacom digitizer in these don't get calibration its kinda based off the hardware. Do you have a magnet nearby the device, or if you put your old tip back in is it still an issue with that one minus being used up? Or is it just the new tip?
Malcolm
rvcjew is offline   Reply With Quote