Thread: DR800 Build process problem
View Single Post
Old 06-18-2010, 04:51 PM   #6
Iņigo
Guru
Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.Iņigo did not drink the Kool Aid.
 
Posts: 730
Karma: 72743
Join Date: Feb 2008
Location: Here or there
Device: iRex iLiad, iRex DR800S. K4NT. Kobo Aura, Aura One, Libra 2.
Quote:
Originally Posted by CoolDragon View Post
Thanks. I figured this out. I have never used intltoolize before.

Another question: what make target should I use to make a release build. My compiled popupmenu is way bigger than the original one: 233k vs 68k.
that's because the binary contains debug information.
Run strip against it.
Btw, not the strip binary in /usr/bin, but the ine in /usr/local/poky/arm.../bin
Iņigo is offline   Reply With Quote