Quote:
Originally Posted by knc1
Quote:
Originally Posted by pcwizzy37
Quote:
Originally Posted by knc1
Quote:
Originally Posted by pcwizzy37
Quote:
Originally Posted by knc1
Quote:
Originally Posted by pcwizzy37
I have a kindle 4 NT that i bricked by exporting storage from diags and then deleting ENABLE_DIAGS, when I connect it to my computers it shows up as NS Blank CODEX and USB Human Interface Device. is there a software tool that can use that connection or the serial port to fix the board id?? please reply.
P.S. I have an Arduino Due, if that helps.
|
The few actions that you describe would not have bricked your K4.
There must be other things/actions involved.
Use KUBRICK.
|
KuBrick does not work, I cannot even get it into fastboot anymore.
|
Kubrick is just a 'wizard' that runs the command line utilities.
There isn't anything else to try.
What would help is if you would answer my question -
What things did you do that you have not yet mentioned?
|
What I did (or at least what I remember)
I jailbroke the kindle,
I installed KUAL,
I installed KoReader,
I installed duokan OS,
I used a program in KUAL to run commands(just find, ls cat /proc/cpuinfo, maybe others but I do not remember),
I created ENABLE_DIAGS and rebooted,
i did some things in diags, I forgot what, but I think I was going to try to enable ssh.
then I did what I said a few messages back.
I have to get off my computer. but willctry to remember more and send you information.
|
Although written for the Pw-1,
The sentiment is the same:
https://www.mobileread.com/forums/sho...48&postcount=8
|
I was told to make this public.