Rooting problem
Ok, I decided to take the plunge, you guys seem to be having way too much fun.
But I'm having a problem, and I can't figure out where I'm going wrong. If any of you guys have any ideas, I'd be forever grateful!
I downloaded nooter 2.12.25. (My Nook Color is 1.0.1)
I used WinImage to write the disk image on a sd card on my computer. The 4 files on the sd card are exactly the same as shown in the directions.
I shut down the Nook by holding the power button down and selecting the power off button.
I installed the sd card in the Nook, and attached the cable.
The Nook powers up, but boots to the B&N screen. My computer will not recognize the Nook until I slide the wake up bar across, and then it goes into USB mode.
Funny thing is, once in USB mode, the Nook Color shows up on my computer as g:nooter2.
I've tried it a dozen times, but it does the same thing. I have no idea what I'm doing wrong. Anyone?
Az
|