Hello guys,
I am following this manual, but when I flash u-boot.bin using mgftool2.exe the serial console stops on this and it does not go further:
Quote:
CPU: Freescale i.MX6 family TO0.0 at 996MHz
Temperature: 35 C, calibration data 0x5a15215f
mx6sl pll1: 996MHz
mx6sl pll2: 528MHz
mx6sl pll3: 480MHz
mx6sl pll8: 50MHz
ipg clock : 66000000Hz
ipg per clock : 66000000Hz
uart clock : 80000000Hz
cspi clock : 60000000Hz
ahb clock : 132000000Hz
axi clock : 198000000Hz
emi_slow clock: 22000000Hz
ddr clock : 396000000Hz
usdhc1 clock : 198000000Hz
usdhc2 clock : 198000000Hz
usdhc3 clock : 198000000Hz
usdhc4 clock : 198000000Hz
MMC: FSL_ESDHC: 0,FSL_ESDHC: 1,FSL_ESDHC: 2
|
mgftool reports an error:
Quote:
ModuleID[2] LevelID[10]: *********MxHidDevice[037C1E80] Jump to Ramkernel successfully!**********
ModuleID[2] LevelID[1]: PortMgrDlg(0)--MxHidDevice--Command Boot excute failed
ModuleID[2] LevelID[10]: CmdOperation[0], current command executed failed, so SetEvent(hDevCanDeleteEvent)
|
Do you know what is wrong with it?