Thread: New PW3 arrived: Comparing it to Nook Simple Touch
View Single Post
Old 10-10-2017, 09:04 PM   #11
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Firmware version is 5.8.9.0.1
That is (was) the source of your problems.
That is not a firmware released for customer use, it is a firmware build used for production quality control testing only.
You can't expect it to work the way a customer use firmware does, because it is not one.

= = = =

Start over with your testing and your review, anything prior to the update is not relevant to a customer use device.
Note: You could have jail broken that version if you had wanted to, it is a special case of the current directions (does not need the installation of a "factory_initial" firmware build because it already is (was) running a "factory_initial" build).
Last edited by knc1; 10-10-2017 at 09:07 PM.
knc1 is offline   Reply With Quote