Quote:
Originally Posted by Starson17
Yes it did. I just tried it. It grabbed the print link you wanted ..... of course, that's not the end of the story. You still have to make the page work. Try looking at the source of the page.
All the content you want is in there.
Which road do you want to go down next - fix the non-print version or fix the print version?
|
Actually, the way it is now is fine, its not perfect but its very readable.
I do have one question. I was going through the calibre page for converting rss, and in the section on 'slicing and dicing' I was wondering where the code shown is from? And am I supposed to copy that entire code into the recipe? Or is this something else?