|
No, I think that is for bad situation verified with my DR1000.
As I wrote in my message there is an opened case with new firmware.
Yesterday the support wrote to downgrade to FW 1.7, but I can't, the reader didn't read at all from SD and so I could do nothing.
I think that it's possible dangerous to install new firmware, and I'm waiting a solution by iRex support.
Sorry for my bad English writing (I'm Italian), I hope that you can understand.
Bye
Erminio Mostacci
This 2.0 RC1 seemed to have bricked my DR, it installed and when it was about to restart into the new firmware. Nothing. Screen is all blank and only the power (orange) up led and bottom middle led are lit. Tried all kind of resets as well. I tried also to use a new SD card and original IREX SD card formatted. Nothing. DR1000 is completely blocked.
I tried all possible downgrade to beta 0401, 0408 and to firmware 1.7.1, nothing, always a blank screen and the power (orande) up led and bottom middle led are lit.
I opened a case at iRex American support.
By the way, for now, I think that it's better to not use new release of firm
|