|
No, I haven't seen this but I'm using the dailybuilds. I installed the dailybuild oi-hanlin-v3ext-install-20100515 version a few days before I went on holidays.
I checked it for about 2 days and decided to leave it installed for my holidays in Egypt (where I did a lot of reading). I did discovered that, after reading for many hours, the e-reader got completely blocked (even no flashing green led so I had to reset the Hanlin V3ext several times) and also that it sometimes jumped to a random page after I clicked on page forward. I've also noticed that sometimes, after reading for many hours, the reader became very unresponsive (only the green led showed activity) so I think there is a memory leak.. I've avoided it during the rest of my holidays by closing a book after a few hours reading and then re-open it.
I was reading in the plane for a few hours and as Egypt is in a different time zone, I decided to adjust the time...well after about 20 minutes of looking at the flashing green led, I decided to give it a full rest (note that I always have a paper-clip in the cover of the e-book for these circumstances). If you change the date/time immediately after power up, it goes fine, but don't do it after reading many hours.. (still have to test this with the new dailybuild I've installed by now)
I've already installed dailybuild oi-hanlin-v3ext-install-20100527 and as soon as I see the same problems popping up again, I'll create a problem ticket. But back in normal life, I do read a lot less than I when I'm on holidays, so it may take a few days...
|