MobileRead Forums - View Single Post

ASnoopyDOG · 05-14-2010, 07:23 AM

Try following:

- Boot your device N516.
- Connect USB.
- Press 'Rotate' button of your N516. While you press the button reset your device by using small hole on back side of the device.
- Now you can take your finger from 'Rotate' button.
- Windows 7 will search for a device calling ' jz4740 usb boot device'.
- You can break the automatic driver search of windows.
- Go to your device manager of windows.
- Look for your new device (calling 'Usb_Boot_device' / ' jz4740 usb boot device' or 'unknown device'.
- Select the driver 'Usb_Boot_Driver.inf'
- A message appears that the driver is not signed, accecpt this!
- Installing process of the device while take a few minutes. Wait!
- You will see under 'Igenic Usb Boot Class' the device 'Usb Boot Device'.
- Now you can start boot.exe as described in the description for flashing your device.

Regards,
ASD

05-14-2010, 07:23 AM	#2
ASnoopyDOG Member Posts: 12 Karma: 10 Join Date: May 2010 Location: Germany Device: Hanvon N516 - patched with Scriba V.2.5.3.2 Firmware	Try following: - Boot your device N516. - Connect USB. - Press 'Rotate' button of your N516. While you press the button reset your device by using small hole on back side of the device. - Now you can take your finger from 'Rotate' button. - Windows 7 will search for a device calling ' jz4740 usb boot device'. - You can break the automatic driver search of windows. - Go to your device manager of windows. - Look for your new device (calling 'Usb_Boot_device' / ' jz4740 usb boot device' or 'unknown device'. - Select the driver 'Usb_Boot_Driver.inf' - A message appears that the driver is not signed, accecpt this! - Installing process of the device while take a few minutes. Wait! - You will see under 'Igenic Usb Boot Class' the device 'Usb Boot Device'. - Now you can start boot.exe as described in the description for flashing your device. Regards, ASD Last edited by ASnoopyDOG; 05-14-2010 at 07:29 AM.