Quote:
Originally Posted by dwanthny
Just a side note: There have been a few instances on this board where people with quite a few books on a SD card had to turn off metadata reading from the device so they wouldn't have to wait 20 minutes after hooking up their device to send other books to it.
|
I send books to my device while the library is building.
Even with Meta-data-off, the process takes about a minute per 100 books
and
Also blocks changing of preferences (i use 2 different save templates. Series and No series., that are quite different).
Would it be possible to have Calibre acknowledge a detected device ONLY (not build a library)
and (regardless of the above)
Add a Manual
Refresh library list,
per Storage detected?
Current Calibre requires ejecting the device, then reattaching and allowing the entire process to run. again.
Lots of minutes used
up