MobileRead Forums - View Single Post - Help for Noob on installing Open Inkpot on Hanvon ereader

overflo · 05-09-2010, 01:32 AM

I have read the instructions but still need some help.
Firstly, oes the SD card need to be formatted?
from the website:
Download flashimage firmware and unpack it. - I presume on computer NOT SD Card but not 100% sure
then from README file:
Connect the device via USB - Check!
Power on Device - again Check!
New device will appear in your system, point to this directory for driver. - First I have 2 devices showing - I presume one is the device itself and one is the SD Card. So does point to this directory mean I use the command prompt to point to the root directory of the device? (i.e. not the SD Card)
Sorry if I sound simple but I would like clarification before I start.

Thanks in advance

05-09-2010, 01:32 AM	#3
overflo Junior Member Posts: 8 Karma: 10 Join Date: May 2010 Device: Hanvon n516	Install on Hanvon n516 I have read the instructions but still need some help. Firstly, oes the SD card need to be formatted? from the website: Download flashimage firmware and unpack it. - I presume on computer NOT SD Card but not 100% sure then from README file: Connect the device via USB - Check! Power on Device - again Check! New device will appear in your system, point to this directory for driver. - First I have 2 devices showing - I presume one is the device itself and one is the SD Card. So does point to this directory mean I use the command prompt to point to the root directory of the device? (i.e. not the SD Card) Sorry if I sound simple but I would like clarification before I start. Thanks in advance