MobileRead Forums - View Single Post - PRS-500 Simple instructions for adding a clock and joystick page turns to the PRS-500

Pierrot · 08-08-2007, 12:56 PM

A hitch after the fact:

I deleted the flasher off of my SD card after successfully installing it on my reader. Later I loaded some books on the card to transfer to the reader; when I inserted the card, the flasher's install screen appeared. I hit 7 for "switch to firmware update mode" and received the following error message:

error copying libfskLoad to /tmp/

That screen stays in place for a second, and then a screen appears that reads

Run script
If this message stays for a long time, something went wrong.

--followed by the flasher's ordinary instructions. That message does stay a long time, but if I hit MENU it disappears. This happens every time I insert my SD card.

Any advice would be appreciated.

08-08-2007, 12:56 PM	#27
Pierrot Junior Member Posts: 3 Karma: 10 Join Date: Aug 2007 Device: Sony Reader PRS-500	A hitch after the fact: I deleted the flasher off of my SD card after successfully installing it on my reader. Later I loaded some books on the card to transfer to the reader; when I inserted the card, the flasher's install screen appeared. I hit 7 for "switch to firmware update mode" and received the following error message: error copying libfskLoad to /tmp/ That screen stays in place for a second, and then a screen appears that reads Run script If this message stays for a long time, something went wrong. --followed by the flasher's ordinary instructions. That message does stay a long time, but if I hit MENU it disappears. This happens every time I insert my SD card. Any advice would be appreciated.