Thread: M-Edge cover
View Single Post
Old 04-09-2010, 07:44 AM   #14
Jumpn Jack Flash
Lazy Git
Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.Jumpn Jack Flash is no ebook tyro.
 
Posts: 124
Karma: 1266
Join Date: Jun 2009
Location: The soggy Emerald Isle
Device: iRex DR800S
Quote:
Originally Posted by trekchick View Post
The light works better if it's farther away from the screen. Try extending it as high as possible and aim it toward the middle. I'm getting most of the screen illuminated, but with fair-poor coverage in the upper/lower corners nearest the light .
I have also rotated the unit as most people are doing in order to use the switch, so the light is at the bottom of the unit now. I find I get better light coverage by sliding the light out of the slot by about an inch.

The stylus holder is seems to be for the small stylus not the big one sent to the European customers, have stuck the clip of the stylus into it but it is not really a long term solution.

I however do not think that the unit is too wide, but it is up to each to make their own decision. I was more annoyed that the spring for the battery fell off and rolled away on opening the unit, I don't think I shall see that again. I had to roll up some solder use that too complete the circuit.
Jumpn Jack Flash is offline   Reply With Quote