Quote:
Originally Posted by jen6060
Hi - I finally plucked up my courage to try to soft root, but seem to hit a hiccup. Actually I've had my nook for a week plus. So I did update to 1.2 firmware before I decided to give soft root a try. I followed instructions, dragged the Bravo 1.0 file to Nook drive. But the device went to version 1.1, instead of 1.0.
After which when it started up, it prompted me to register, and I did (I prob shouldnt have). After registering it promptly started to update itself to 1.2. So I'm back to square one. Why is it that when I dragged the bravo 1.0 file to Nook, it went to 1.1 and not 1.0? Perhaps I shouldnt hv updated to 1.2 when i first received it?
How do I make it revert to 1.0? I'm a bit afraid to try again bec it seemed to take so very long to reboot, a few attempts in fact. Thanks so much ..
|
Did you download 1.0 from here?
http://www.multiupload.com/YWHOXQKYVS
Did you rename it to "signed_bravo_update.dat"?
I've softrooted twice. After the first successful installation I decided against it. But later on I did it again because of exchanging the SIM.
Between those 2 installations I had the original 1.2 as well, so this can't be it.
Rebooting a few times is strange. Normal procedure should be: You copy it to nook (the renamed 1.0). nook recognises it and automatically does the reflash. nook reboots only once (as far as I remember). You're back to the original 1.0. Don't spend time with it, don't register. Immediately do the 1.2 update (with the modified 1.2).