Joember
PRS+ does next to no changes to the original firmware, 99% of the code is javascript located in internal memory. If your device is connected to USB then PRS+ doesn't even start. Problems like you've described are usually results of incompatible Rootfs/Fsk partition combination. If you had UK firmware it could be the reason. I'm almost done with PRS+ installer, that will get rid of such problems.
505's are sort of "unbrickable", in the worst case you'd need to do 10 timely resets (you have to reset right when you see the startup screen, otherwise code that says "oh, I could load just fine" will fool the antibrick mechanism) in a row and it'll fall into firmware upgrade mode.
Last edited by kartu; 02-28-2010 at 05:29 PM.
|