MobileRead Forums - View Single Post - PRSCustomizer: Customize and personalize your PRS505 Reader

kimah · 02-08-2010, 04:14 PM

Hello...while I have been lurking around here for quite some time this is my first post. I finally got up the courage to try the PRScustumizer after reading the entire thread on it and thinking I would ok.

I had firmware version 1.1.01.25200. which was not supported so I did option 7 to try and reload the firmware from sony to 1.1.00.18040. I followed all of the instructions on sony's site. My reader was fully charged. But now I have been stuck on "installing new software" for around 3 hours.

What do I do now? Shouldnt have messed around with it since I have never had any problems until now. And I was in the middle of a REALLY good book too.

thanks in advance for any help!!
K.

02-08-2010, 04:14 PM	#830
kimah Junior Member Posts: 5 Karma: 10 Join Date: Feb 2010 Location: Illinois, USA Device: PRS-505	Hello...while I have been lurking around here for quite some time this is my first post. I finally got up the courage to try the PRScustumizer after reading the entire thread on it and thinking I would ok. I had firmware version 1.1.01.25200. which was not supported so I did option 7 to try and reload the firmware from sony to 1.1.00.18040. I followed all of the instructions on sony's site. My reader was fully charged. But now I have been stuck on "installing new software" for around 3 hours. What do I do now? Shouldnt have messed around with it since I have never had any problems until now. And I was in the middle of a REALLY good book too. thanks in advance for any help!! K.