MobileRead Forums - View Single Post

fjf · 02-02-2010, 09:51 AM

Using the new firmware 2.0, converting files from rtf (that are apparently well and open in openoffice or word perfectly) to epub (files that are less than 500 Kb, about 275-325 pages in the epub output). The Cybook works well until somewhere in the middle of the ebook, and then reboots when I get to certain page and try to change page to the next one. Sometimes I can avoid it by jumping to a page beyond that "rebooting border". Sometimes I cannot, and converting the file again I can jump beyond that page. But the rebooting limit usually stays. Anyone found a problem like this one?. Any possible solution?.

Thanks.

02-02-2010, 09:51 AM	#1
fjf Connoisseur Posts: 57 Karma: 470712 Join Date: Jan 2008 Device: Kindle Scribe, TCL Nxtpaper 14	Problem with epub output in Cybook Gen3 Using the new firmware 2.0, converting files from rtf (that are apparently well and open in openoffice or word perfectly) to epub (files that are less than 500 Kb, about 275-325 pages in the epub output). The Cybook works well until somewhere in the middle of the ebook, and then reboots when I get to certain page and try to change page to the next one. Sometimes I can avoid it by jumping to a page beyond that "rebooting border". Sometimes I cannot, and converting the file again I can jump beyond that page. But the rebooting limit usually stays. Anyone found a problem like this one?. Any possible solution?. Thanks.