Quote:
Originally Posted by badbob001
In regards to your use of the word standby, which you earlier defined as suspend-to-ram, can I assume the two standby states above are the same (standby from brief slide of switch and standby from 30 minutes inactivity)?
|
Yes, they are identical.
Quote:
|
How is this standby state different from what was provided to the dr1000s as of firmware 1.5?.
|
DR1000 does not have this standby mode. It only has the low power sleep mode (sometimes referred to as "suspend"), which DR800 uses too. Sleep mode is entered when the device is idle for a few seconds, the display content is retained. During standby, the display is cleared.
I try to avoid the therm "suspend-to-RAM" as is a misleading. It generally only applies to the OS and micro processor, where power management on the device involves a whole lot more hardware. Technically the sleep mode and standby both suspend to RAM, but they are very different.