Quote:
Originally Posted by lighty
I just bought another BeBook and installed OI 0.2. Installation went fine, BeBook rebooted and I got into OI menu (BTW nice looking GUI). I opened books, tried a few features and no problem there either. Then I turned everything off. When I tried to turned it on next time nothing happens. LED turns red and everything gets stuck and what's more not even Reset button is doing anything- it just turns LED to green when it's pressed but when it's released LED is again red and the whole thing is stuck.
|
That seems to be what has been said to happen when you install the wrong version of the OI firmware for the Hanlin V3. Did you download oi-hanlin-v3ext-install-0.2.zip
OR oi-hanlin-v3-install-0.2.zip ? If you have a 512MB Hanlin V3 and you installed oi-hanlin-v3-install-0.2.zip you would probably experience what you described. oi-hanlin-v3-install-0.2.zip is for the older 64MB Hanlin V3, and you need oi-hanlin-v3ext-install-0.2.zip for the 512MB Hanlin V3. The differences are described in a bit more detail in the Installation Guide:
http://openinkpot.org/wiki/0.2/InstallationGuide