View Single Post
Old 12-06-2009, 04:01 PM   #32
jlbfoot
idiot
jlbfoot began at the beginning.
 
jlbfoot's Avatar
 
Posts: 91
Karma: 16
Join Date: Nov 2008
Location: Grand Cayman
Device: Sony 505, 300, and 650
Bricked 300!

After considerable thought, I decided to go ahead and try to flash my 300 with the Boroda method, using the file that only gives the clock and Unicode fonts. I unzipped the file, copied and pasted the "Sony Reader" folder into the root 300 drive that had "database" on it, and pulled the USB plug. The reader appeared to go through the screens, as it was supposed to, then rebooted. That is where I got stuck. I get the "Opening Book..." screen, then a message that "Firmware update did not complete successfully. Please try again".

I've tried the multiple resets in succession without success. The only thing I can see on my readers drive is a file called "protected!!" and I can't access the drive on the reader.

Any suggestions, beside get a new reader. I will if I must, and I knew the risks. Just have to borrow my wife's reader until I get this fixed, or I make it back to the States. Thanks!

Last edited by jlbfoot; 12-06-2009 at 05:18 PM.
jlbfoot is offline   Reply With Quote