Thread: PRS-600 Wrapsol
View Single Post
Old 11-05-2009, 03:03 PM   #8
terekkincaid
Connoisseur
terekkincaid doesn't litterterekkincaid doesn't litter
 
Posts: 58
Karma: 196
Join Date: Oct 2009
Device: nook
I just got a Wrapsol protector for my 600 as well. Compared to every other screen protector I've purchased in the past (Writeshields, Invisible Shields, you name it) for all kinds of devices (phones, computers, handheld games, etc.), I've never seen a gap between the edges of protector and the edge of the screen as large as this one. With the screen protector centered, there are 2-3mm of space on each side. I know there needs to be a small bit of space for putting it on and taking it off, but this is way too much. Dust and dirt settle into this crevice.

I sent an email to the company, and they told me this space was normal for putting the protector on properly and for "heat dissipation". That's a new one to me, and sounds like a load of bull, especially on an eInk-based reader. Does anyone else with the Wrapsol protector have that kind of gap between the film and the edge of the screen, or did I get a badly cut one? I sent the attached photos to the company (that is the white backing paper that is the exact same size as the film - I used it in the photos since it is easier to see) and am awaiting a response.
Attached Thumbnails
Click image for larger version

Name:	IMAG0110.jpg
Views:	345
Size:	670.4 KB
ID:	38603   Click image for larger version

Name:	IMAG0109.jpg
Views:	357
Size:	518.9 KB
ID:	38604  
terekkincaid is offline   Reply With Quote