MobileRead Forums - View Single Post - SmartQ 7 Customization: Stock OS

Mothergoose · 10-05-2009, 02:13 PM

Hi All,

Just received my Smartq 7 and installed Firmware 5 on it.
Now I am trying to load the comic reader on it with the 2 files from page 1.

While installing python-imaging I am getting the following error:
Wrong architecture 'arm'

i search the whole internet (or at least it feels like it) but can not get any further.
Does anybody can help me?

Thanks from the Netherlands

UPDATE: OK, I suddenly remembered what could cause this...... it is ARMEL!!
Is anyone willing to help me with Python-imaging and Comix which should work on ARMEL??

10-05-2009, 02:13 PM	#23
Mothergoose Junior Member Posts: 2 Karma: 10 Join Date: Oct 2009 Device: smartq7	Hi All, Just received my Smartq 7 and installed Firmware 5 on it. Now I am trying to load the comic reader on it with the 2 files from page 1. While installing python-imaging I am getting the following error: Wrong architecture 'arm' i search the whole internet (or at least it feels like it) but can not get any further. Does anybody can help me? Thanks from the Netherlands UPDATE: OK, I suddenly remembered what could cause this...... it is ARMEL!! Is anyone willing to help me with Python-imaging and Comix which should work on ARMEL?? Last edited by Mothergoose; 10-06-2009 at 05:03 AM. Reason: Update