Thread: PRS-600 Bad luck with my PRS-600
View Single Post
Old 09-12-2009, 09:23 PM   #2
shrktank
Connoisseur
shrktank has learned how to buy an e-book online
 
Posts: 83
Karma: 92
Join Date: Sep 2009
Location: Imperial,Mo
Device: Sony 650,Nook Color and iPad
Saw this on another issue someone had. It is instructions to reset to factory defaults

Here's the procedure he gave me for resetting the device back to factory default:

Note: Performing this procedure will delete any content you have stored on the Reader.

1). With the reader off, using a paper clip or similar device, press in and hold the Reset button on the back of the unit for 5 - 10 seconds.

2). Release the reset button and power on the reader.

3). While the reader is booting, press and hold both the Volume Up and Mark Buttons. Continue holding until you see a screen asking you to confirm that you want to reset the device back to factory default (Press Button 5). Note: I had to hold down these buttons for about 60 seconds to get the confirmation screen. Also about half way through this process, you should see a blue light flash momentarly around the lower left Page button.

4). After you have confirmed you want to set the device back to factory default, the reader will turn off. Turn the unit back on and it will go through its initial startup which takes a minute or two.
shrktank is offline   Reply With Quote