Quote:
* If the device is on, slide the "Power" so that it turns off. Look for a small pinhole on the back panel (not the side, that's the charging indicator LED) and press the reset button on the back using a bent paper clip (do not use anything sharp like a pin).
* Slide the "Power" button to turn it on. While the screen displays "Starting up ...", you will see the light above the "Power" button flash in yellow. Wait for 35 to 40 seconds, then proceed to hold down the "MARK" and "VOL +" buttons.
(NOTE on the PRS505, do not wait those 35~40 seconds, push and hold the "Mark" and "VOL +" buttons immediately -- the boot window is shorter on 505s)
* CONTINUE TO keep these 2 buttons pressed for about 5 to 10 seconds, until the round "PAGE" button makes a quick blue flash.
|
I cant turn it off unless, I press the reset then the orange light goes out. Holding down the "MARK" and "VOL +" buttons for over 1 min straight after turning on after reset does nothing.
Quote:
1) press reset
2) connect USB cable
3) toggle power switch
|
toggle power switch, doesnt change the LED color (red) or screen ("Starting Up") when connected to the PC