Quote:
Originally Posted by Mackx
If I looked good in the published code, I expect the dr1000.ini file to be written when you shutdown the DR. Did you do a shutdown? That is why can only change the dr1000.ini file when the DR is off. (I.e. remove card and use card-reader to modify the content of dr1000.ini on your PC.) Otherwise the settings that are in memory are written back to dr1000.ini when you shutdown.
|
Hmm, I thought so too. I did that before resorting to the PC companion, and it didn't seem to do it. But maybe it didn't shut down cleanly... it's sometimes hard to tell, and the reason I started the whole process was because it was starting to act funny (*) I also noticed the PC companion adds its own settings, like the Inbox login etc. (Will the Inbox ever be used for anything?
)
(*) Like locking up after a few minutes of inactivity (i.e. related to the power management?) I re-installed 1.6 too, for good measure.
Quote:
PS: The problem of deleting the dr1000.ini file is that you also use the stylus calibration data and the icons you dragged to your toolbar. So better rename the dr1000.ini file so you will be able to merge-back the parts that you want to keep, incase you want to delete your dr1000.ini file (which I do not advice  )
|
That's the reason I did it in the first place: I redid every setting, incl. calibration, without the card inserted and I wanted to make sure it would write those values back into a fresh dr1000.ini. Anyway, the ability to re-assign the file associations is a great find.